MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 12)

5.0 Installation & Setup

Figure 3

5.3 Cleaning

After unpacking, wipe down all machine panels and clean the table surface.

5.4 Fitting Through Narrow Door

The Titan 200 cutter will not fit through an opening less than 36” (91 cm) without the table being

removed. With the table removed, the Titan 200 will fit through a 35” (89 cm) opening. With the

table, front guard, and foot treadle removed, it will fit through a 28” (71 cm) opening.

5.4.1 Removing the Table

Make sure the knife and clamp are in the “up” position. If they are not, read the Power Hookup

section (page 17) to connect power to the machine. Turn on the power using the red and yellow main

power switch, close the front guard, and press the CLEAR button. This will preset the backgauge and

send the knife and clamp up.

Turn off the machine and unplug the power cord.

If equipped with electric eyes, remove the electric eye mounting brackets, the small side tables, and

the side table mounting bracket from bottom of table.

Remove the cut buttons from the bottom of the table.

Remove the Plexiglas cover and the three sheet metal covers on the rear of the table. Remove the

backgauge motor cover, the rear table support leg, the lower back panel, and the lower front cover of

the machine.

Unplug the cable to the encoder at the back of the machine (Figure 4 on page 12).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 12