
5.0 Installation & Setup
Line Light
Adjustment
Screw
Figure 15
5.9.1 Adjustment
1. Place a wide sheet of paper on the cut stick to view the line light.
2. Using a 3/16” hex allen wrench, turn one of the cap screws until you see a 1/16-1/8” beam. Note:
it is best to start by turning the screw clockwise. If the screw turns all the way in before a line
appears, begin turning the screw counterclockwise.
3. Similarly, turn the adjustment screw of the other bulb, until one continuous beam is seen across
the cut stick.
5.9.2 Bulb Replacement
1. Make sure power is off and unplug the machine (see Power Lockout Procedure, page 5).
2. Open the front guard (if equipped).
3. Remove the old bulb by lightly pushing the bulb into the socket and turning it counterclockwise.
CAUTION! If the bulb is still hot, allow a few minutes for it to cool.
4. Insert the new bulb into the socket and twist it clockwise until the bulb locks into place.
5. Reconnect power and turn the main power switch on. Readjust the line if necessary.
18
Comentários a estes Manuais