MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 13)

5.0 Installation & Setup

Encoder Plug

Rear Support

Figure 4C

Remove the motor junction box cover and disconnect the wires to the motor (Figure 5). Remove the

leadscrew cover and the nylon tyraps that are attached to the bottom of the table. The motor wires

and encoder wires should now be free from the table.

Motor Junction

Box Cover

Figure 5

From the rear of the machine, remove the presetter board assembly from the table (Figure 6 on page

13).

Open the front guard (if equipped); open the top cover and remove the left and right side guides and

the cut stick stops as shown in (Figure 7 & Figure 8 on page 13).

Next, remove the cut stick from the table using the cut stick removal tool. Locate the two taper pins in

the cut stick slot. These must be tapped out from under the base through the table slot and removed.

Then remove the four screws that mount the table to the base. NOTE: The table assembly is very

heavy and requires two people to remove. Pull the table out from the back of the machine. Locate

the four round spacers that were between the table and the base - you will need them later for

mounting the table.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 13