MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 23)

6.0 Operation

6.8 Display Panel

Dis

SEND Ke

IN/MM Ke

Variable Speed

Pinpoint Backgauge

Control

Soft

Keys

ENTER Ke

CLEAR Ke

Push-Out Ke

Arrow Keys

Priority Add

(X/Y) Key

Figure 19

6.9 Definition of Keys

6.9.1 Variable Speed Pinpoint Backgauge Control

The backgauge control is used to manually position the backgauge. The speed of the backgauge will

depend upon where the actuator is pressed. Press farther from center for a faster speed. Press

toward the operator for forward direction and away from the operator for reverse direction.

6.9.2 IN/MM Key

This key toggles the display to show the position and programmed send values in inches (e.g. 5.250),

inch fractions to the nearest 1/64” (e.g. 5_

), or millimeters (e.g. 133.3).

6.9.3 Send Key

The SEND key is used to send the backgauge to any valid position. If an attempt is made to send the

backgauge to an illegal position, an error message will be displayed at the bottom of the screen

stating “Number outside limit”. In the Job mode, the SEND key will also advance the backgauge to

the next sequential cut position before performing the cut.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 23