MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 36)

7.0 Knife Installation/Changing

Knife Adjusting Screws

Figure 22

3. Remove the knife bolts from the two slotted knife bar holes and replace with the knife lifter

assembly (Figure 23). Tighten the lifters to hold the knife in place, and then remove the

remaining two knife bolts.

Figure 23

4. Clear the table surfaces and place the empty knife scabbard on the table. Remove the

scabbard’s knife retaining screws.

5. Grasp the knife lifters firmly and, at the same time, turn them counterclockwise to release the

knife from the knife bar (Figure 24). Lower the left end first, then lower the right end as you shift

the knife sideways to the left. Bring the right end of the knife around the knife bar guide frame.

Maneuver the right end into the space between the guide frame and the shroud as the left end is

brought clear of the left guide frame. Move the knife to the right then bring the knife out of the

cutter, left end first. Put the blade in the scabbard immediately and secure the knife retainer

screws.

Figure 24

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 36