MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 17)

5.0 Installation & Setup

Dip Stick

Figure 12

5.7 False Clamp Plate (Optional)

To prevent marking on pressure sensitive jobs, a false clamp plate is available as an optional item for

your machine. This plate attaches to the bottom of the clamp. It is secured with wing nuts on studs

that pass through the top of the clamp.

To install:

1. Make sure the knife and clamp are in the up position. If they are not, turn on the power using the

red and yellow main power switch, close the front guard, and press the CLEAR button. This will

preset the backgauge and send the knife and clamp up.

2. Turn the power off and disconnect the power cord.

3. Open the front guard (if equipped) and slide the false clamp plate under the knife and clamp

(Figure 13) and slide the plate up into position with the locator pins toward the front of the

machine. The locator pins insert into holes in the bottom front of the clamp.

4. Hold the plate in position and secure with the wing nuts provided.

5. Change the false clamp setting of the machine to ON to prevent the backgauge from crashing

into the false clamp plate. This is done in the Maintenance Mode/Parameters/False Clamp

screen. For more details on how to do this, see page 25.

NOTE: The minimum cut with the false clamp plate attached is 1-3/4”

Locator

Pins

Figure 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 17