MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 43)

8.0 Maintenance Guide

Fluid level should be at 1/8” from the end of the dip stick (check with dip stick cap screwed in). Add

fluid if necessary but avoid overfilling as this could cause leakage when hot. Replace the rear panel

when finished.

The hydraulic fluid should be changed AT LEAST ONCE-A-YEAR or after every 1,000 hours of

operation. NOTE: Failure to change oil when needed can damage seals in the cylinders, pump, and

valves.

Empty the hydraulic tank and refill with 1 gallon of International Standards Organization Viscosity

Grade 100 (ISO VG 100) rust, oxidation, and foam inhibiting hydraulic fluid (Challenge part no.:

S-1991).

NOTE: NEVER use automatic transmission fluid or brake fluid as a substitute for the correct

hydraulic fluid. A table of various manufacturers and their equivalents is listed below.

8.2.1 Recommended Hydraulic Oils

Use one of the recommended oils or an ISO VG 100 Hydraulic Fluid

equivalent only. Oils other than the recommended type will cause seals and O-rings to deteriorate.

Unsafe operating conditions will result.

Oil Name Distributor

Rykon No. 100 AMOCO

Duro AW Oil 465 Arco

AW Machine Oil 100 Chevron

Pacemaker XD No. 100 Citgo

Super Hydraulic 100 Conoco

Nuto H-100 Exxon

Harmony 100 AW Gulf

HO 2A Hydraulic Oil Lubriplate

DTE No. 18 Mobil

Pennzoil AW 100 Pennzoil

Magnus A Oil 215 Phillips

Tellus 100 Shell

Energol HLP 100 Sohio

Industron 100 Std. Oil

Indiana/Boron

Sunvis 851 WR Sun Oil Co.

Rando HD 100 Texaco

Unax AW 100 Union Oil Co.

8.3 Oil and Grease

Turn the power off and disconnect the power cord. Open the front guard (if equipped) and open the

top hood for access. Parts requiring oiling are marked with red paint. See figures Figure 27 through

Figure 34 starting on page 43 for oil and grease locations. Figure 27 through Figure 29 require the

knife and clamp be in the up position. Figure 30 through Figure 34 require the knife and clamp be

down. Wipe off any old or excess grease. Use any brand-name type of grease or light oil to

lubricate. It may be necessary to use the supplied grease brush to access some locations. Note: the

leadscrew may be lubricated with grease or oil. Oil has a tendency to run off and must be lubricated

more frequently; grease tends to collect paper dust and must be cleaned off periodically.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 77 78

Comentários a estes Manuais

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 43

Comentários a estes Manuais