MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 21)

6.0 Operation

5.000 in

A) Maint

B) Job

The backgauge may now be sent to a desired position by simply typing the dimension and pressing

SEND (see the Send Mode section, page 24, for more details).

6.3 Making a Cut (Machines With Electric Eyes)

Place the paper against the backgauge and left side guide. Note: If the cut will leave strips of paper

less than 1/2” wide, place the paper against the right side guide. This will prevent the strips from

getting caught in the small opening near the left side guide.

To make a cut, make sure there are no obstructions between the electric eyes, and press both cut

buttons (located beneath the front face of the table) within 1/2 second of each other. Hold the buttons

in until the knife reaches the table. Releasing the cut buttons at any time during the cut cycle will

immediately send the knife and clamp to the “up” position.

6.4 Making a Cut (Machines With Front Guard)

Open the front guard and place the paper against the backgauge and left side guide. Note: if the cut

will leave strips of paper less than 1/2” wide, place the paper against the right side guide. This will

prevent the strips from getting caught in the small opening near the left side guide.

To make the cut, close the front guard and press both cut buttons (located beneath the front face of

the table) within 1/2 second of each other. Hold the buttons in until the knife reaches the table.

Releasing the cut buttons or raising the guard at any time during the cut cycle will immediately send

the knife and clamp to the “up” position.

Note: The guard must be opened and closed each time a new cut is made.

6.5 Jogging Aid

Always remove the jogging aid from the table before making a cut.

A jogging aid is included as standard equipment with the Titan 200. This tool allows the operator to

load and align paper without the need to place hands or arms under the knife or clamp.

To use, load the paper against the side and backgauge using the jogging aid (Figure 17 & Figure 18).

Remove the jogging aid from the table, close the guard, and make the cut.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 21