MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 20)

6.0 Operation

IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL

YOU HAVE THOROUGHLY READ AND UNDERSTAND ALL OF THE FOLLOWING

INSTRUCTIONS. CALL YOUR AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY

QUESTIONS.

6.1 Power – Main Switch

Power is brought to the machine when the main power switch is turned to the “ON” position (Figure

16). The display and line lights are turned on at this time. The hydraulic motor will not be activated

until a cut cycle is initiated, and it will shut off after the completion of the cut cycle.

Figure 16 –Power On-Off Switches

OFF ON

The display and line lights will shut off after 5 minutes without any activity. This shut-off time can be

changed in the Parameters screen of the Maintenance Mode (section 6.12.2 on page 25). To restore

power to the display and line lights, press any button on the keyboard or lift up the front guard (if

equipped).

6.2 Start Up

Once power has been turned on, the Titan 200 will show the following display:

55.000 in

Backgauge must move to be preset.

Please clear the table and close guard.

Warning! Clamp and Knife may move.

Revision 1.0

Press clear to start

A) Maint

B) Job

When the CLEAR key is pressed the clamp and knife will move up if they are not already in the up

position (provided the front guard is closed, if equipped). Then the backgauge will move to

coordinate the true position into the computer. When finished, the machine will be in “Send Mode”

and the display will appear similar to the display shown on top of the next page.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 20