MyBinding Standard 3030x Manual de Instruções descarregar pdf (Página 22)

6.0 Operation

Figure 17

Figure 18

6.6 Knife Change Alarm and Lubrication Alarm

The Titan 200 has two built in alarms that will be displayed after a certain number of cuts. The knife

alarm displays a message that notifies the operator to change the knife. The lube alarm displays a

message that notifies the operator to have the machine lubricated. The lube alarm will also display

the name and phone number of the Challenge dealer from which the machine was purchased. To

reset either alarm, or to change the knife alarm value, see 6.12.2.5 Knife Count, page 26.

NOTE: The alarms do not prevent normal operation; they are simply reminders.

6.7 Manual Clamping (Using the Foot Treadle)

The Titan 200 is equipped with a manual clamping feature, which allows the operator to manually

clamp paper before beginning the cut cycle. To use this feature, press down on the foot treadle until

the clamp comes down on the paper. While holding the foot treadle down, close the guard (if

equipped) and press both cut buttons. Release the foot treadle once the cut has been completed.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 77 78

Sem comentários

MyBinding Standard 3030x Manual de Instruções Página 22